Installing Arch Linux on UEFI with LVM
GPT partitioning, LVM volumes, file systems and mount points for an Arch Linux installation on UEFI.
This guide describes how to partition a disk for UEFI with LVM before installing Arch Linux (or an Arch-based distribution). Device and volume names (/dev/sda, arch-lvm) are examples to adapt. The commands below erase the data on the target disk.
Partition table
Create a GPT table with three partitions: an EFI System Partition (ESP), a /boot partition and a partition for LVM.
| Partition | Range | Role |
|---|---|---|
/dev/sda1 |
1 MiB to 513 MiB | EFI System Partition (FAT32, boot flag) |
/dev/sda2 |
513 MiB to 800 MiB | /boot |
/dev/sda3 |
800 MiB to 100% | LVM physical volume |
parted /dev/sda
(parted) mklabel gpt
(parted) mkpart ESP fat32 1MiB 513MiB
(parted) set 1 boot on
(parted) name 1 efi
(parted) mkpart primary 513MiB 800MiB
(parted) name 2 boot
(parted) mkpart primary 800MiB 100%
(parted) name 3 lvm-partition
(parted) print
(parted) quit
LVM volumes
parted /dev/sda set 3 lvm on
parted /dev/sda print
pvcreate /dev/sda3
vgcreate arch-lvm /dev/sda3
lvcreate -n arch-root -L 20G arch-lvm
lvcreate -n arch-swap -L 2G arch-lvm
lvcreate -n arch-home -l 100%FREE arch-lvm
lvs
File systems and mount points
mkfs.fat -F32 /dev/sda1
mkfs.ext2 /dev/sda2
mkfs.btrfs -L root /dev/arch-lvm/arch-root
mkfs.btrfs -L home /dev/arch-lvm/arch-home
mkswap /dev/arch-lvm/arch-swap
swapon /dev/arch-lvm/arch-swap
mount /dev/arch-lvm/arch-root /mnt
mkdir /mnt/{home,boot}
mount /dev/sda2 /mnt/boot
mkdir /mnt/boot/efi
mount /dev/sda1 /mnt/boot/efi
mount /dev/arch-lvm/arch-home /mnt/home
Then install the base system with the distribution installer (or pacstrap), and generate the fstab file:
genfstab /mnt >> /mnt/etc/fstab
GRUB on a UEFI virtual machine
Replace /path/to/esp/mountpoint with the mount point of the EFI partition (here /boot/efi in the installed system).
grub-install --target=x86_64-efi --efi-directory=/path/to/esp/mountpoint --removable