Linux: replacing net-tools with iproute2
Mapping from the deprecated net-tools commands (ifconfig, route, arp, netstat) to their iproute2 equivalents (ip, ss) on Linux.
The iproute2 package replaces the deprecated net-tools package (ifconfig, route, arp, netstat). The tables below map the common commands. Changes made with ip are runtime only and are lost at reboot; make them persistent with NetworkManager or the distribution's network configuration.
Command mapping
| Task | net-tools (deprecated) | iproute2 |
|---|---|---|
| List all interfaces | ifconfig -a |
ip link show |
| Enable an interface | ifconfig eth1 up |
ip link set dev eth1 up |
| Disable an interface | ifconfig eth1 down |
ip link set dev eth1 down |
| Add an IP address | ifconfig eth1 192.0.2.10 netmask 255.255.255.0 |
ip addr add 192.0.2.10/24 dev eth1 |
| Remove an IP address | (no direct equivalent) | ip addr del 192.0.2.10/24 dev eth1 |
| Show one interface | ifconfig eth1 |
ip addr show dev eth1 |
| Change the MAC address | ifconfig eth1 hw ether 00:11:22:33:44:55 |
ip link set dev eth1 address 00:11:22:33:44:55 |
| Show the routing table | route -n or netstat -rn |
ip route show |
| Add a default route | route add default gw 192.0.2.10 |
ip route add default via 192.0.2.10 |
| Add a static route | route add -net 192.0.2.0/24 dev eth1 |
ip route add 192.0.2.0/24 dev eth1 |
| Link state and speed | mii-tool |
ethtool |
| Wireless information | iwconfig |
iw |
Legacy tools and their replacements
| Legacy command | Replacement | Purpose |
|---|---|---|
arp |
ip neigh |
Neighbour (ARP) table |
iptunnel |
ip tunnel |
Tunnels |
nameif |
ip link set dev OLD name NEW |
Rename interfaces |
ipmaddr |
ip maddr |
Multicast addresses |
netstat |
ss, ip -s link, ip route |
Sockets, statistics and routes |
Enable and disable an interface
ip link show
sudo ip link set dev ens192 down
sudo ip link set dev ens192 up
Manage an interface with NetworkManager
nmcli device
sudo nmcli device disconnect ens192
sudo nmcli device connect ens192
sudo nmcli device set ens192 managed no
sudo nmcli device set ens192 managed yes
Statistics and sockets
ip -s link
ss -s
netstat -s | head -11
cat /sys/class/net/eth0/speed
The last command prints the link speed in Mb/s; it only works while the link is up.
Wi-Fi with nmcli
nmcli device wifi list
nmcli device wifi connect "SSID" password "PASSWORD"
nmcli device wifi connect "SSID" password "PASSWORD" hidden yes
nmcli radio wifi off
Restart the networking service
| Distribution family | Command |
|---|---|
| RHEL / CentOS (legacy network service) | sudo service network restart |
| Debian / Ubuntu (legacy networking service) | sudo service networking restart |
| NetworkManager based systems | sudo systemctl restart NetworkManager |