MTU and IP fragmentation: check and change on Windows and Linux
Read, test and change the MTU and detect IP fragmentation with netstat, ping and Wireshark.
An MTU that is too small, or too large for a path, causes IP fragmentation or dropped packets. This note shows how to read and change the MTU on Windows and Linux, how to test a path with the "do not fragment" flag, and how to spot fragmentation.
Read the MTU
Windows:
netsh interface ipv4 show interfaces
netsh interface ipv4 show subinterfaces
The output lists, per interface, the index, metric, MTU, state and name.
Linux:
ip addr | grep mtu
Test the path MTU
Send packets that must not be fragmented. If the size exceeds the path MTU the ping fails.
Linux (8972 = 9000 minus 28 bytes of IP and ICMP headers):
ping -M do -s 8972 <destination_ip>
Windows:
ping -f -l 9000 <destination_ip>
Check whether fragmentation happens
Windows:
netstat -sp ip
netstat -s | findstr Fragm
Linux:
netstat -i
ss -s
netstat --statistics | head -10
nstat
Sample output of netstat --statistics (Ip section):
Ip:
68728385 total packets received
1 with invalid headers
56871060 forwarded
0 incoming packets discarded
4093729 incoming packets delivered
57898402 requests sent out
65 outgoing packets dropped
8 fragments dropped after timeout
3240 reassemblies required
Useful counters are fragments dropped after timeout and reassemblies required. A reference for Linux network statistics: Linux network statistics reference.
In Wireshark, this display filter shows fragmented packets:
ip.flags.mf == 1 or ip.frag_offset gt 0
ip.fragment also matches fragments. A sample capture of fragmented traffic (teardrop.cap) is available on the Wireshark wiki.
Change the MTU
Windows (persistent; the index or interface name comes from the commands above):
netsh interface ipv4 set interface "<idx>" mtu=1500 store=persistent
netsh interface ipv4 set subinterface "Ethernet" mtu=1518 store=persistent
Linux, temporary:
ip link set dev eth0 mtu 1300
Linux, raw datagram size limit:
sudo sysctl -w net.inet.raw.maxdgram=16384
For a persistent sysctl setting, edit /etc/sysctl.conf.